Due to COVID-19, all training activities have been cancelled until further notice. This platform will be updated according to how things will evolve in the upcoming weeks.


GEM® 3X00, 4000 and 5000 Service Training

12 October 2020 09:00 – 16 October 2020 14:30
Location: Werfen - Milano, Viale Monza 338, Milano, Lombardia, Italy
Category: Acute Care Service
 

Day 1 (09:00 to 18:00)

Introduction of the Blood Gas Analysis

  • Clinical Objectives
  • Parameters measured
  • Electrodes (Theory of operation)
  • Cartridge (structure - shelf life - stock conditions)
  • Electrodes Calibration
  • Fluidic cycles (iQM)

GEM® Premier™ 3000

Instrument Description

  • Operating Menu
  • Difference between GEM® 3000 and 3500 in the menu
  • Cartridge insertion
  • Analysis simulation
  • WEB description

Day 2 (09:00 to 18:00)

Practical session

  • Dismounting of the panels
  • Views and description of the internal components
  • Electronic description

Practical session 

  • Dismounting of the panels
  • Views and description of the internal components
  • Software Installation

Practical session

  • Electronic description
  • List of the Errors (Log of the instrument)
  • Troubleshooting
  • Service Parts List
  • Answering questions

GEM® Premier™ 4000

Instrument Description

  • Co-Ox theory
  • Spectrometer Description
  • Cartridge (structure-shelf life-stock condition)

Day 3 (09:00 to 18:00)

GEM® Premier™ 4000

Instrument Description

  • Instrument Start Up
  • Menu Configuration

Practical session

  • Analysis simulation
  • Views and description of the internal components
  • Disassembly mains assembly of the instrument
  • Heater Block – Co-ox Optical Head – Spectrometer

Day 4 (09:00 to 18:00)

Practical session

  • Software Installation
  • Instrument configuration (standalone/client)
  • Introduction to GEMweb® Plus

Practical session

  • Final Test with GTE and ETC
  • List of the Errors (Log of the instrument)
  • Troubleshooting
  • Service Parts List

Closing the training

  • Answering questions

Day 5 (09:00 to 18:00)

  • Discuss GEM® 5000 intended use
  • Discuss Cartridge types – parameters available
  • Discuss iQM2
  • Setup unit for operation
  • Navigate screens
  • Perform Calibrations
  • Run Quality Control
  • Run Samples
  • Cartridges – Replacement
  • Maintenance
  • Identify all GEM® 5000 components
  • Fluidic Cartridge functionality and troubleshooting
  • Understand how to install a GEM® 5000
  • Component removal and replacement
  • Adjustments – Diagnositcs: New diagnostic software and ETC box

* The ones that have a wide experience on GEM Premier 3000 may join the training starting from Day 2 at 14.00 attending only the GEM Premier 4000 session


BOT EV-01BOT EV-02BOT EV-03BOT EV-04

EEMEAI Training courses and congresses filter

QUICK CALENDAR

Go to top